ANYONE KNOW HOW TO CHANGE THE XFORM DEFAULT SETTINGS?
I HATE EVERY TIME I HAVE TO ROTATE OR ANYTHING ELSE, I HAVE TO CHANGE IT TO MOVE, AND NOT COPY. REALLY ANNOYING.
ANYONE KNOW HOW TO CHANGE THE XFORM DEFAULT SETTINGS?
I HATE EVERY TIME I HAVE TO ROTATE OR ANYTHING ELSE, I HAVE TO CHANGE IT TO MOVE, AND NOT COPY. REALLY ANNOYING.
Did you check under Configuration > CAD Settings > Preview >Maintain? You might want to spend some more time reading the help file (press F1 key). Almost all the information is in there.
HEY TXCNC, HOW YOU BEEN?
NO I HAVENT LOOKED UNDER CONFIG YET. I THOUGHT IT WOULD BE UNDER CUSTOMIZE. BUT THOUGHT I WOULD CHECK HERE BEFORE I STARTED CHANGING ****. I WILL LOOK INTO IT TOMORROW. THANKS FOR THE REPLY. GOOD TO SEE YOUR STILL HELPING OUT.:wave:
I always have to ask what version as there are changes over the years. as it is not the same from say v8 and v9 then again from MC-X to MC-X6
Also the newer versions will remember your settings thru out your session once you use it once. there are no direct option for setting to Move vs Copy.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .