[jeanyes]

The finishing passes sometimes pass through areas which are not supposed to be cut. This seems to happen only when I use Regions. Here's a screenshot of the simulator which clearly shows the problem:



For the example above, I had set up regions so that only the rope pattern was cut. The roughing pass worked without any problems. The z levels also worked. It was during the Planar finishing that the errors are made.

Any help would be greatly appreciated.

[turmite]

send me your email via pm.

I help Joakim with a bit of support here in the US,

Mike

[jeanyes]

@turmite: Done! Thank you.