hello all,
I recently found myself in a situation where a fella twisted off and I have to pick up and run with a machine called "the zayer" with an 840c...any help would be appreciated.
thanks,
otis
hello all,
I recently found myself in a situation where a fella twisted off and I have to pick up and run with a machine called "the zayer" with an 840c...any help would be appreciated.
thanks,
otis
ok....how close to the 840d is the 840c?
I am wondering if I can use fanuc drilling cyles on this mill with G290 and a G291
also does anyone have a example of how you are stacking code for this
controller?
It is a bed mill with a knuckle head...
thanks again
hey thanks again,
Does anyone have any advise about swaping from metric to inch?
Hello Otis
We have a Zayer in our factory, it's a spanish machine; ours has Heidenhain control but we have also several other machines with 840C and I have some knowlege with this control...IF I caan help..
Repbob
repbob,
Thanks.....our machine currently reads and displays in the metric system, I would like to change it to inches. Also x and y axis' are swaped positive for negative. Its a beast 46' in the x axis.
hello Otis,
my compagny is closed now but I will return there on december 26 for one day and have a look to our documentation for Siemens 840C.
If I understand well you want to change the machine from metric to inch and you want to change the sign of X and Y.
I don't understand what you mean by " beast 46' in the x axis." Sorry english is not my mother language!
Repbob
Hello Otis,
1) to switch between metric/inch:
push menu key (down right), push parameters, push bit settings, push arrow right( not the one on the keyboard, the one to expand menu), then you have a key to switch Inch/metric. But I noticed that some manufacturers cancel this perhaps to avoid errors, I don't know..
This depends also wich soft you have on your machine.Let me know..
2) to change the sign of one axe:
change NC MD(MD=machine data= parameters) 564* bit 2. * means the axis number; 5640 is for first axe, 5641 for second one etc...Here also be careful, I don't know if it's OK with your soft
Best regards
Repbob
Repbob,
Many thanks....its software version 5. By "beast" I mean its rather large, 46 feet of travel in the x axis.
It might be a day or two before I can get back with the results.
Thanks again,
otis