[kalle100]

Hi
I need to shange in the ladder of the machine
looking around and fanuc ladder iii is the program for it ?
and where can i find it easy?

[underthetire]

From fanuc. ~1800$.

[kalle100]

hmm quite expensive .

[drdos]

What is your CNC controller type? Some Fanuc controllers will let you edit on the control.

[Al_The_Man]

What is your CNC controller type? Some Fanuc controllers will let you edit on the control.

The only ones I have seen that allow that have an eprom cassette that is downloaded to local prom and then ran, but once you power down the changes are lost?
Al.

[memoryman]

fladder or faptladder; that software is available online.
All controls that have their ladder on flash memory can be edited (maybe an option) and saved. The system 15a can save and run the ladder from the pmc-ram board.

[gbowne1]

I don't have the PMC - RAM board on my 15A I have been looking for
one.

[memoryman]

I bought one for a customer of ebay several months ago; around $600

[gbowne1]

I noticed they are quite expensive on eBay and often only 1 or 2 show up.

Anyone here do FANUC Ladder programming? I need their services. :-)

[Shoprag]

I can edit the 15M-A control. What type of changes are you needing? What edition of ladder logic are you using?

[memoryman]

You can edit, but without a PMC-ram board, you cannot save it in the control.

[Shoprag]

I have the RAM board, Fanuc PC-Writer and copies of FAPT 1 and 2. If you can send me the ROM cassette I can pull the ladder off of it and make the modifications. I will burn the changes and send the cassette back. Send a PM with your information.

[gbowne1]

I need basic ladder(s) built for mostly 3 axes / 4 axes rotary CNC bed type milling machines and these would be for the following controls:

6M B2
16M model B
18iM Model A
0M model C

And..

10TF
0T model C

[Shoprag]

That would be a lot of work. Check your PM for a message. I can write ladders for all of these except the 6 and 10 models.

[memoryman]

Greg, the FS6 requires a special programming box that few have.
In general, it is much better if you can write a ladder yourself and can test/modify it immediately.
Shoprag, I have some limited experience writing ladders; a new project I started is being able to take the raw eprom ladder data of a FS6 (other models later) and incorporate it in a viewable, editable dynamic ladder running on a PC. Maybe we can exchange info?

[gbowne1]

It's ok I don't need the 6 or 10 ladder right away.

I have all the specifics on the machines, travels, servos, etc. Everything is FANUC hardware on the control side. I have all the board part numbers, etc.

The 15M Model A is running but its only running a pretty basic ladder which works and it fit on the A02B-0094-C103 cartridge, although I have the -C163 ROM cartridge too.

I would like to be able to get the 16M running soon as well as the 0M.

If that works great I will finish with the 18iM

All my machines are pretty much milling machines that are just like the Leadwell 550, Mori Seiki MVJr, Mori Seiki MV40, Okuma-Howa Millac 3VA, etc.