Are these encoders worth anything used? I have them on my tnc131, and could possibly use them as an easy way to add my new AMD encoders, but would require me destroying them. If they are worth anything, I guess I rather sell them, but if not I want to start tearing it apart to see if I can make installing my new encoders easier.
thanks
Thread: heidenhain rod450b encoders
Results 1 to 2 of 2
-
10-15-2012, 06:55 PM #1
Registered
- Join Date
- Mar 2011
- Posts
- 273
heidenhain rod450b encoders
-
10-15-2012, 07:09 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24221
The ROD450 series were low signal sine wave output, so of no use for TTL differential use, unless the conversion box is used, They should be worth a bit in the used market as these a pricey to buy.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
HEIDENHAIN encoders ERM 280 speed encoder
By sammmy_s in forum CNC Machine Related ElectronicsReplies: 3Last Post: 03-11-2012, 01:51 AM -
Connecting Heidenhain Encoders
By BTS in forum CNC Machine Related ElectronicsReplies: 4Last Post: 06-27-2011, 02:29 PM -
cheap absolute encoders? Oxymoron? Decent Incremental encoders?
By mattbesquare in forum Benchtop MachinesReplies: 15Last Post: 09-09-2010, 12:56 AM -
HEIDENHAIN encoders any good?
By mattbesquare in forum Servo Motors / DrivesReplies: 5Last Post: 02-22-2010, 05:59 AM -
Encoders
By ramasule in forum DIY CNC Router Table MachinesReplies: 3Last Post: 12-24-2007, 07:27 PM
Posting Permissions
