Does anyone know how to toggle between "absolute" and "relative" displays when in the program check mode? It always used to be displayed in absolute but somehow it got switched to relative.
Thread: Help with O mate control
Results 1 to 3 of 3
-
01-17-2006, 07:51 PM #1
Registered
- Join Date
- Jan 2006
- Posts
- 2
Help with O mate control
-
01-18-2006, 01:22 AM #2
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
Call Fanuc. They may help. You must have a Discovery 308 with the 0M MATE control. I found that control very tedious. You have to cursor over to anything you want to do. Very time consuming. Do you have a parameter manual? The answer may be in there.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
01-18-2006, 12:26 PM #3
Registered
- Join Date
- Jan 2006
- Posts
- 2
Thanks for replying. It ia a GE Fanuc Series O Mate-M on a Bridgeport interact 720. You're right though, it is a very tedious control and you must go from window to window to accomplish anything. I do have all the manuals but they are just as useless. It states that you can toggle back and forth between Relative and absolute but does not tell you how to do this.
Reply With Quote
Posting Permissions
