Any one know of an enexpensive 30v power supply that will work with the xylotex?
Any one know of an enexpensive 30v power supply that will work with the xylotex?
I build my own by rewinding old microwave transformers. There is a how to in the magazine section.
Art
AKA Country Bubba (Older Than Dirt)
Whats inexpensive? Here's a 28V supply. http://www.mpja.com/productview.asp?product=16023+PS
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
thanks, that is what i was looking for.
How much more power would that increase over the 24v i already have, percentage wise?