[getdog]

Hi
I have a cnc MAX REBEL 1 with control Fanuc O-M.
How to activate DNC mode? The selector panel options are: Edit, auto, MDI, Handle, Teach in Handle, Teach in Jog , Jog and Zero Return.
if I select auto mode and send these are stored in memory, live not run.

thanks

[Al_The_Man]

Depends on the version, but usually the option selector switch is installed by the OEM, as the PMC ladder requires the BMI register G127.5 set on by the switch.
Al.

[getdog]

Is version C.
concerning the register G127.5, is a parameter change or modified hardware?

Thanks for reply

[Al_The_Man]

The G registers are ones that the PMC send to the CNC side, F registers are from CNC to PMC.
So it requires a run to be written into the ladder and a switch fitted normally.
Al.

[getdog]

Hi
worked in this way:

In mode MDI run M51 code and press cycle start
after in mode AUTO press again cycle start
on screen display LSK.
Ready for send from PC.

[Farhan96]

Hello
I have a Kitamura Mycenter 1 with a Fanuc OM controller. The parameters were erased by mistake on the controller. I obtained a copy of the parameters from the manufacture and have re-entered them. Upon power up I do not get any alarms on the CRT but I do get "not ready" in the lower left corner. I also get "THND" on the CRT in the position normally displaying "MDI", "EDIT" etc. Any help would be appreciated.

Thanks