Originally Posted by
chucker
Got a new Lynx 220 LMS last week the tech left the machine on when he was done today I went over to play with it and when I give it a S500 M3 the sub spindle ran and not the main I could not get the main to run at all I shut down the machine down and back on now S500M3 runs the main spindle I give the machine a S500 M103 and the lathe will just sit there with the cycle light on and the spindle never comes on no alarm chuck is clamped this also happens on the live tooling with S500M33 I can give it S500M203 and run both spindles M205 will stop them also when I give the lathe S500M3 them M5 I get an alarm that says program not found this is because in parameter 6083 there is a 5 and no 9023 program to go with it, the tech left a test program in the machine using the M5 so if he ran it, it alarmed out on him as well or the 5 was put in 6083 after he ran it I am the only 1 here that knows how to put the 5 in 6083 to cause this. I have 4 2500 SYs ans 2000 and 230s they all work with these M codes.Am I missing something or is someone playing games here I dont want to cry foul if I am missing something.