we have our new table with our new controller. sweet but we cannot get the mach to read voltage so thc is a little useless everything tests ok up to the rav01 and thats where it gets odd next test fails miserably and there is no troubleshooting in between the two tests. at a loss here we need the machine. components are as folllows
hypertherm powermax 1000
bulltear 4x4
bladerunner ubob w dthc II
sheetcam and mach 3 installed by bt
the plug and play is shorting out here i am sure it is something simple and even an ommission or mistake by me but i cannot seem to get this running