[GPappy]

Does anyone know of a source where I might get a schematic for a servo driven Mill. The Jetmatic that I have came with no documenation and the wiring had been hacked up by the previous owner. I think that I will need to gut the electronics and start from scratch reusing as much as possible but would like to have something to start with.

Thanks in advance.
Greg

[fmederos]

Hi,
If a 1985 Sharnoa SDC30 vertical mill schematic is of use I can send it to you.

Regards,
Fernando

[GPappy]

Fernando,

Anything would be better than the nothing I have right now. The Jetmatic I have is from about the same vintage and would assume that the basic design would be similar. If you could email to gandjpappy at aol dot com, I would appreciate it.

Regards,
Greg

[fmederos]

Here is a PDF with the circuits contained in the Sharnoa manual.
It covers a series of Sharnoa SDC machines from SDC20 to SDC80. It looks like there were changes at some point, the first pages seem to be the oldest version.

http://www.mederoscnc.com/images/Cir... SDC20..80.pdf

Regards,
Fernando

[GPappy]

Fernando,

Thank you so very much. This is what I have been looking for. I appreciate the effort you put into scanning and posting these schematics.

Regards,
Greg