Hello gents, I've just finished building my first axis board and PSU.... I need a quick intro and file to test system...I only have Turbocnc available on the PC... is there a quick, short program or way of testing one axis.... many thanks
John
Hello gents, I've just finished building my first axis board and PSU.... I need a quick intro and file to test system...I only have Turbocnc available on the PC... is there a quick, short program or way of testing one axis.... many thanks
John
You can use MDI mode and just type G1 commands.
G1 X10
G1 X1
G1 X10
.......
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
many thanks...IT WORKS..... clever stuff thum thar puters!
Any way to enable pin 14 low via the software...It's been a long time since I found my way around DOS based stuff.
john