[RdHawg]

In 5ax mode with TRAORI and Cycle832 active My feedrate of 90IPM does fine in a straight X/Y/Z move but then slows to a crawl when a B or C move is called out. (Utilizing a bunch of tiny G1/Vector moves)

The Hypermill Tech seemed to think it was the job of the controller to advance the B/C Feeds to keep the same SFM of part going past the tool. The machine tool tech feels that the holdup is the C axis rotating at 90IPM (as measured at the outside dia of the table)

How do I keep a consistent feedrate at the tooltip?

Thank you,
Brian

[RdHawg]

For those that might also be struggling with this. It was suggested by my Hypermill tech guy to change the Cycle832 setting from finish to pre-finish or roughing. Worked great - I think I actually got a better finish on my pre-finish part. Part times were 33,12,8 mins respective - same program just changed the mode.