585,992 active members*
6,309 visitors online*
Register for free
Login

Thread: help error multicam 3000

Results 1 to 4 of 4
  1. 01-26-2013, 11:49 PM #1
    jovanifive
    jovanifive is offline Registered
    Join Date
    Aug 2008
    Posts
    63

    help error multicam 3000

    good afternoon
    urgent help me
    I have a multicam 3000
    and after working for a few hours
    in the morning, this afternoon the machine
    did not respond, giving me the keyboard
    The following error
    "motor fault 23
    XA
    And
    Z
    blink count 15
    logic power backed up
    XB blink count 15
    logic power backed up "
    I could help me
    that is what I have to check
    in the cabinet of the drivers

    I appreciate any help
    Reply With Quote Reply With Quote
  2. 01-28-2013, 02:27 AM #2
    jovanifive
    jovanifive is offline Registered
    Join Date
    Aug 2008
    Posts
    63
    Thanks and resolved to failure!
    Reply With Quote Reply With Quote
  3. 01-29-2013, 04:15 PM #3
    MCPservice
    MCPservice is offline Registered
    Join Date
    Jun 2010
    Posts
    463

    Help Error Multicam 3000

    Can you post a pic of your control cabinet, I think your breaker for the servo drive has tripped. But I would like to see you control cabinet, they have located this breaker at least 2 different places inside of the cabinet.
    Reply With Quote Reply With Quote
  4. 04-19-2022, 04:55 PM #4
    mikepro
    mikepro is offline
    Join Date
    Jan 2021
    Posts
    10

    Re: help error multicam 3000

    i just had same error, resolved by servicing the ABB contactor near the control boards in the cabinet. it was stuck in the contact position even when powered-down.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. multicam 3000 motor error 23 "help anyone"
    By murfeedean in forum Multicam Machines
    Replies: 3
    Last Post: 01-26-2013, 11:37 PM
  2. servo error - MULTICAM 3000
    By ugan.git in forum Commercial CNC Wood Routers
    Replies: 3
    Last Post: 04-04-2012, 04:12 PM
  3. Multicam 3000 Error: "Warning Low Voltage (4.89VDC 0.00 VAC)
    By lukaspanic in forum Commercial CNC Wood Routers
    Replies: 2
    Last Post: 05-14-2009, 02:43 AM
  4. Multicam 3000 low airpressure error, please help
    By lukaspanic in forum Commercial CNC Wood Routers
    Replies: 4
    Last Post: 04-12-2008, 01:29 AM
  5. MultiCam 3000 error message
    By DRolph in forum Commercial CNC Wood Routers
    Replies: 1
    Last Post: 01-11-2007, 10:30 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules