does anyone have a post any processor for the brother TC-228?
thanks
does anyone have a post any processor for the brother TC-228?
thanks
I took this off of bobcad suppost and are you looking for tc-22a or tc-228
thanks for the quick reply, however i dont think that post will work. that seems to output gcode and the controller on the 228 (afaik) accepts motion programs/conversational programs which dont look anything like g-code. however i could be all wet and just havn't got the controller completely down yet.
see if the controller will accept stander EIA for G-M code most al controller will read it or maybe stamder ISO format
I have TC-221 and it only accepts the conversational programming. I have seen Brother machines that do accept EIA/ISO (G code) programs, but I'm fairly certain
that this is an option. Do a web search and contact Yamazen via email or phone
with your machine serial number and they may be able to tell you whether you have
g-code capability. If your machine is pre-1990 they may be very little help at all.
For what software are you looking for a post?
Can you send and receive programs via RS-232 and if so, what software are you
using?
Good luck
Ben
Thank you
I need to Know about CNC brother TC-20A and TC-203C Tapping Center
use a program format G-code and post by SolidCAM can be use
CAD/CAM
Many of the old Brother Converstional machines can be converted to run G-Code. The machine's control panel, and several IC chips on the NCPCB need to be replaced. Parts will typically cost around a couple thousand bucks, and take a few hours to install by a technician.
Contact Yamazen:
877-271-1933
We are developing a G-Code to Brother Conversational Converter at the moment. We are still using something like this in our company. The converter is able to convert any simple G-Code to a brother motion program.
Please contact [email protected] if you are interested in this.
Thank you
CAD/CAM
Hello,
I've sent a couple of emails to your email link and have received no response.
Is the g-code to brother motion control converter software available?
I would really like to try it and buy it if it's what you say it is.
Thanks
Ben
My email is [email protected] please tell me Title and you name on email
i don't know why my email not response and Thank you agant
Ben
CAD/CAM
hi, everyone, My name is rick , Very new here, Hoping can share and learn from here.
Thank you. my e-mail is [email protected] , My Tc228 NCPCB has spoiled ,need repairing or replacement, Does anyone know where to get a replacemnet or get it repair?
I have the faulty NcPCB for TC228. brother.
Thank you,
Hi!
I have a problem with brother TC-211.
I get the message "POSITION ERROR (Z)" and I don't know what to do.
Manual says just "press RESET key and check time constant"
What exactly should I check with the time constant?
Can anybody help me?
Answers can also be sent to [email protected]
thanks
One other thing I would like to know is does anybody know how to control the additional 4th axis of the brother TC-211.
I know that CODE 81 makes the axis move, but how do I control the angle of rotation?
Answers to [email protected]
thanks
It will give you this alarm if the rapids are below 250 IPM.
To get out of this alarm, Hold the RELSE (KEY) and Jog Z down.
That control can only send and receive m-codes which are only simple on off triggers and the port is only good for m-codes and commands to run programs already stored in the internal memory. Example you send a signal from a computer through the port that tells the mill to run internal program number 1000. M-codes are simple on off pulse, the degrees of rotation are controlled by a seperate controller for the rotary table.
can brother tc 203 cnc accept g code ?