Hi All,
I have a strange problem with a Fanuc Controller. The Machine has just been through some major repairs. The gearbox was repaired and also the mainboard on the 31i was replaced. The issue that we have is that the machine does not have an automatic tool changer. So, they will have a M0 in the program. The machine will stop and change the tool manually and then press cycle start to continue with the program. The operator is pressing the cycle start button and nothing is happening. I notice that when the program is running it has 2 lines highlighted. One line has black writing with the background highlighted in Turquoise and then the line below it the writing is highlighted in blue. when the program stops then the M0 is highlighted in blue.
Does anyone here have an idea what is going on? I phoned Fanuc and they have no idea.
Results 1 to 1 of 1
-
11-13-2023, 06:59 AM #1
Member
- Join Date
- Jul 2012
- Posts
- 18
Fanuc 31i automatic not restarting after M0
Reply With QuoteSimilar Threads
-
Fanuc 0-T axes stop working about 11 seconds after restarting.
By iowa_jim in forum FanucReplies: 0Last Post: 05-23-2021, 09:42 PM -
Postprocessor for SolidCAM (FANUC OI-MD + FANUC Robodrill 31i model A)
By pereval in forum Post Processor FilesReplies: 1Last Post: 04-14-2014, 07:41 PM -
Restarting the spindle after spindle stop while in automatic/tape mode on a VMC
By PhoenixMetal in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 06-27-2013, 09:11 PM -
Absolute zero lost when restarting machine (Fanuc 0M)
By Steve427 in forum FanucReplies: 9Last Post: 10-31-2012, 10:24 PM -
Restarting Fanuc 21i-TB in prog middle or after tool break
By underdog in forum FanucReplies: 4Last Post: 06-06-2009, 02:01 PM
Tags for this Thread
Posting Permissions
