Err / Reset Fault Indication.
Is there a way to determine or indicate the fault source?
Thread: G320X Fault Source
Results 1 to 2 of 2
-
03-03-2013, 03:47 PM #1
Registered
- Join Date
- Oct 2008
- Posts
- 2100
G320X Fault Source
Bob La Londe
http://www.YumaBassMan.com
-
03-05-2013, 01:14 AM #2
Registered
- Join Date
- Oct 2008
- Posts
- 2100
The reason I asked this question is that I have a drive that sometimes faults, but even when I can get it to do it while monitoring the drive I can't determine the exact reason. I do not get a yellow warning indication that it is getting out of position before it faults, and it is not over current as the total current for the power supply is not over the current for the one drive when it happens.
My only other thought was encoder circuit noise, but ... well see my other post.Bob La Londe
http://www.YumaBassMan.com
Reply With QuoteSimilar Threads
-
Fault/Reset circuit for G320X drives
By ZincBoy in forum Gecko DrivesReplies: 7Last Post: 12-14-2016, 10:06 PM -
Z Axis fault Error #16 Resolver Fault
By centaur91 in forum FadalReplies: 5Last Post: 10-06-2012, 05:01 AM -
139 x motor z fault and occasional ground fault
By duckslayer in forum Haas MillsReplies: 4Last Post: 05-10-2012, 01:50 PM -
VMC15 fadal, 88HS error#9, spindle driver fault, servo amplifier fault
By kin73 in forum SpanishReplies: 3Last Post: 05-18-2011, 05:26 AM -
Inverter fault / Drive line fault ?
By TMILLS in forum FadalReplies: 2Last Post: 10-21-2010, 03:20 AM
Posting Permissions
