Hi Guys,
I'm working on an old ST40 with a T-32 controller. The tool eye was not in use for years, and now we're trying to get it going again. The sensor itself was replaced with a new one.
Using the procedure in the General Information manual, I set parameter B61 and B62. The problem arises when I go to set B63. When touching off on the sensor, the controller is displaying the distance from HOME POSITION to the tip of the tool instead of the diameter of the barstock. I think there must be another parameter that needs set but I don't know what it is or how to find it and Mazak doesn't answer the phone on the weekends. Any help would be appreciated.
Cheers,
Night Owl