Our MC 3000 has, is losing it's way back to the tool changer rack. Is there any way to correct this? It is off by at least a 1/4" of an inch.
Sending the router home does not correct this.
Our MC 3000 has, is losing it's way back to the tool changer rack. Is there any way to correct this? It is off by at least a 1/4" of an inch.
Sending the router home does not correct this.
So even when you 1st home your machine in the morning, when it goes back to pickup a tool, it is still of 1/4"?
are your large part sizes coming out correct?