Hi
I`m converting my x axis to a servo and am wondering what the
steps per unit would be for the motor tuning in Mach3. I`d like to
have a resolution of .001 don`t know if this is possible.
Servo 360 oz*in at 2175 rpm
5 TPI Ball Screw
US Digital Encoder 250
Gear down ratio : 3 to 1 , 20 Tooth and a 60 Tooth
There is a encoder setting counts/per unit in Mach3...I`m uncertain what
I should use as a value. It looks like two values are needed, one for the
motor tuning : units per step and one for the encoder. I hope I didn`t miss
anything else.
Thanks and Regards, Barry