Does anyone know how the HAAS MOCON comunicates with the drives?
Ie. PWM, step dir, +-10v ect...
Does anyone know how the HAAS MOCON comunicates with the drives?
Ie. PWM, step dir, +-10v ect...
thanks
Michael T.
"If you don't stand for something, chances are, you'll fall for anything!"
Anyone?
thanks
Michael T.
"If you don't stand for something, chances are, you'll fall for anything!"
060218-2156 EST USA
miljnor:
Limited info in the manual.
P3 on servo board. PWM and H drive control signals from Motor Interface and overcurrent sense block. 16 KiloHz, Ilimit 20-22 A, nominal supply 160 V. Continuous power output limited. This determination is in "Motor Interface". Send your fax number if you want a copy of the several pages. Not much information.
.