[bsllc]

Does anyone have a copy of the Bridgeport:
System Wiring diagram, BMI Track Series W/LCD
Drawing #59-1127

I'm trying to find the remote start switch terminals for the EZTRACK controller.
I found a blurry copy in the main control cabinet of the mill, but I can't read the terminal numbers or the connector numbers.

Also, is it possible to drip feed this controller through the serial port?

Thanks.

[machintek]

I have to get to the office and see if I have that schematic. I should.
The original software was designed that the 2 axis did not have DNC capability. The 3 axis did. At version 5, the same disk was used to load both 2 and 3 axis so I believe that both styles should DNC. You would have to read the manual though because my memory is of these doing DNC from the floppy or DOM (disk on a module). I believe the serial port was for program transfer and not for DNC.

George

[dmheiff]

I have a copy its in .tif format so I can not attach it here.
if you send me your email and i can forward it

[machintek]

My apology. I do not have it. I hope the gentleman above came through for you.
I have put the word out to my service engineers that I need a copy.

George

[dmheiff]

on its way.
dave

[bsllc]

Thanks for your help - it is just what I needed.
And thanks to CNC Zone for providing this forum.
-Dan