[nik_chris]

Hello,
I lost the parameters at a Johnford machine center with Fanuc 0M control.
I upload the parametrs from a similar machine. I would like to know what are the parameters from 9000-9899 becaude I can't find any description for them.
Thanks in advance

[Al_The_Man]

The 0M has 900 option parameters, or do you mean the 9000 macro's?
There is a parameter where you can lock them out to avoid accidental erasure.
bit 4 of parameter 0010.
Al.

[nik_chris]

Hello again,
I mean the parameters 9000-9899. Not the macro programs for the tool change (O9000----) or the option parameters 900---.
In the manuals for this control I found no descriptions for these parameters but there were in the back up file for the machine and also at the printed sheet.
I have to notice to you that the control has C.A.P. programming.
My main problem on this machine is that the machine does not execute tool change. I load the macro program i had backup (O9000) but the control does not execute the comand T4 for examble.
There is not need to write M6 just the T code.
I also checked the parameter 40#5 so the T code calls program O9000 but with the comand T the cycle start button remains green and the machine don't get in the O9000 macro.
That is why I need to know what are these parameters, maybe there is a conection with the tool change
Thanks again

[nik_chris]

Hello,
finaly I solved my problem.
Parameters 9000-9899 are for C.A.P. programming. The parameter for tool change is 9898 and this parameter was my problem.
Thanks a lot

[Rafael_Assis]

Hello,
I lost the parameters at a Johnford machine center with Fanuc 0M control.
I upload the parametrs from a similar machine. I would like to know what are the parameters from 9000-9899 becaude I can't find any description for them.
Thanks in advance

Good afternoon!
I wonder if you have the parameters of this machine, because I also have a jonhford fanuc OM and lost my parameters.