[bhpadgett]

Hi Guys,

I recently bought a Lockformer Vulcan 2000 Plasma table. I sent it out for blasting and powder coating. I am in the process of reassembling it now. I am missing some parts
for the gantry but Lockformer no longer supports this product. I have already had a few parts made for it and can get the rest made but I need a service manual and parts list
with diagram if possible. I am willing to pay if anyone would care to make me a copy of theirs.

Thanks

Brian Padgett
Greenwood, SC

[docholidave]

Hi Guys,

I recently bought a Lockformer Vulcan 2000 Plasma table. I sent it out for blasting and powder coating. I am in the process of reassembling it now. I am missing some parts
for the gantry but Lockformer no longer supports this product. I have already had a few parts made for it and can get the rest made but I need a service manual and parts list
with diagram if possible. I am willing to pay if anyone would care to make me a copy of theirs.

Thanks

Brian Padgett
Greenwood, SC

Have you been able to find the manuals you were looking for? I have this machine and the manuals, diagrams, etc for it. Let me know if you still need them.

[Thorbjoern]

Have you been able to find the manuals you were looking for? I have this machine and the manuals, diagrams, etc for it. Let me know if you still need them.

Hi Dave. Do you still have your documentation for the Vulcan 2000. I am trying to revive a 2100 and am afraid I have to scrap the electronics.

[Medlaizis]

Have you been able to find the manuals you were looking for? I have this machine and the manuals, diagrams, etc for it. Let me know if you still need them.

I need a manual for this machine (Lockformer NT 2000). Do You still have any? If so, please write me. Thanks.

[jdubb]

Hi Guys,

I recently bought a Lockformer Vulcan 2000 Plasma table. I sent it out for blasting and powder coating. I am in the process of reassembling it now. I am missing some parts
for the gantry but Lockformer no longer supports this product. I have already had a few parts made for it and can get the rest made but I need a service manual and parts list
with diagram if possible. I am willing to pay if anyone would care to make me a copy of theirs.

Thanks

Brian Padgett
Greenwood, SC

I could use this also. Trying to figure out bad checksum error when booting the machine. Might need to be re-flashed.

[Slavi70]

Hallo ,

i need diagram if possible for Lockformer Vulcan 2000nt,Can not setup the machine.to many parameters.No errors when starting.Serial port is stoped working .And can not cut manualy on the machine .