Hi
I finally got around to tweaking a couple of vids for upload.
First job we ever did.
1/2 inch plate
Hypertherm Powermax 105 PLasma
Hi
I finally got around to tweaking a couple of vids for upload.
First job we ever did.
1/2 inch plate
Hypertherm Powermax 105 PLasma
www.integratedmechanical.ca
Stupid....only one video per post
This job was done 2 or 3 weeks after set up of our new DynaTorch XLR8. Plasma power is Hypertherm Powermax 105.
This is cutting a nested job on a 5 x 10 sheet of 14 gauge steel at 220 IPM
www.integratedmechanical.ca