I have a brand new machine (1100) and I've only put about 6 hours on it. I've been having some strange issues with my ATC. After the first setup, everything was perfect. Now I get a lot of stutter on retraction. I have the rails well lubricated, but it keeps dragging more and more and I've even had failure to retracts. Any ideas there? Second issue, after doing a tool change and jogging, the e-stop throws. It's usually during a Z movement. It makes some whining noises then initiates the e-stop. Anyone run into this? I'm guessing it has something to do with the tool tray retract. I have even pushed it to the rear to ensure it's fully retracted too. Thanks in advance