We are trying to tap 3 off M10 x 1.5 hole using a Fagor 8055i control and BobcadV25 when we run the Prog it does the
C/Drill (Canned) then the Tap Drill (Canned ) but when it gets to the Tapping (Canned) it comes up with Error code 0006
which says there is a minus value somewhere where there should only be a Positive.
The line reads
N88 G84 G98 X0. Y0. Z2.54 I-17.913 K0.5 R1 J100 F1.5 S200
and this seems to be correct or am I missing something as the other Canned part of the Prog run fine.
The co-ords are in G90.
Can anyone see or know where the error could be.