[gurasha]

here is the board I want to buy
CNC 4 Axis Driver 2M542 4 2A Breakout Interface Board for Router System Kit | eBay
with this board if one chip (xis ) burns will other still work fully?

[doorknob]

Since no schematic diagram is provided for the breakout board, it is difficult to give a definitive answer. It would depend somewhat on what you mean by "burn out".

But it would be unusual for one axis of a breakout board to "burn out" because the typical breakout board runs with a fairly low voltage and low current (unlike the stepper motor driver boards that connect directly to the motors).

[gurasha]

Thank you for answer but I think I didn explain quite well. the point is that on this board :
CNC TB6560 4 Axis 3 5A Stepper Motor Driver Board Controller 4 Engraving Machine | eBay

when one axis controling chip gets burned you cant use board anymore this leads to burning other axis chips.


Im interested if I build system with this breakout board. and one of axis controler (not breakout board) will burn vcan I just move on with other axis? e.g. I have 4 axis and one burns. can I use it like

[109jb]

To answer your question. If one motor driver burns out, the others will work fine and will not be affected by the burned out one.

[gurasha]

THank you for answer and dos your answer work for all breakout boards? if one axis burns I can work with others?