[Bill Gillen]

Hi,

I bought a Wasino LJ-63M CNC Lathe a few months ago, and finally got the mechanicals running. Now I want to learn how to use it. It came with an LJ-Series Operator's Manual. However, when I looked at the instructions for MDI and CRT manual (and also other places in the manual) it tells me, "For the details on the MDI and CRT panel, refer to the Operator's manual of FANUC SYSTEM 10T-A.

Does anyone know the best place is to buy a reasonably priced manual for the FANUC SYSTEM 10T-A?

Also, is there anyone in the Gainesville, GA area that would be willing to show me how to use it? I am willing to pay for this service.

Thank you,
Bill Gillen

[Al_The_Man]

If you are stuck for the 10, I have the 15T which is pretty close.
Al.

[sdfoiler]

Al,

Tried to PM you but it says your inbox is full and needs to be cleaned out. I have a quick question for you.

Thanks!

[Al_The_Man]

Since the changes I don't get the message status bar anymore??
I have cleaned quite a few out so try again.
Oh.. I see it has been moved down to the bottom, that is why!!
Al.