I hate suction caps and even if you use some dish washing liquid on them they don't say put forever.
From the pantry I found some aluminium 6061 T6 flat bar that could be used. I went out to my car and measured all the dash and came up with an idea.
In Australia it is illegal to mount your GPS on the windshield and it attracts a fine.
I do not advocate anyone try my design as it could be dangerous.
Ji
Thread: GPS Bracket
Results 1 to 3 of 3
-
05-21-2013, 11:56 PM #1
Registered
- Join Date
- Apr 2013
- Posts
- 89
GPS Bracket
Grip It & Rip It
-
05-21-2013, 11:59 PM #2
Registered
- Join Date
- Apr 2013
- Posts
- 89
My GPS is a Garmin and attaches to its mount via a 17mm diametre ball.
I purchased a ball bearing for this job.
JiGrip It & Rip It
-
05-22-2013, 12:01 AM #3
Registered
- Join Date
- Apr 2013
- Posts
- 89
Job done and GPS mounted.
It only covers the tachometer and on a manual car I don't know why you would need one.
Anyway it is not falling down again.
JiGrip It & Rip It
Reply With QuoteSimilar Threads
-
RFQ - Steel bracket
By bobmagnuson in forum RFQ (Request for Quote)Replies: 2Last Post: 08-04-2011, 02:25 AM -
RFQ: Holddown bracket
By Enraged in forum Employment OpportunityReplies: 6Last Post: 01-19-2011, 05:36 PM -
3D Corner Bracket
By WizzBoy in forum Mechanical Calculations/Engineering DesignReplies: 0Last Post: 08-02-2010, 03:01 AM -
Bracket use on OT control.
By g-codeguy in forum FanucReplies: 4Last Post: 05-23-2009, 04:45 PM -
One bracket made one to go
By cadcam in forum Community Club HouseReplies: 24Last Post: 06-23-2003, 01:09 PM
Posting Permissions
