I have a Baileigh WR23 cnc router.It is a rebadged Chinese 6090. I can't say exactly which one.
It has the RZNC-0501 HBBC usb hand held control. I tried to use my stl files with DeskProto.
They seem to be ok on the usb drive,but the controller can't see them. The drive is a 512 mb
with fat 32 format. Iso files just don't seem to work.
Also the onboard files seem to work, but the bit is above the board, so it is carving air. I have
the C.A.D. for adjusting the Z axis. It touches the disk lightly than goes up,but not where it
shoul be.I have the multi axis version of DeskProto v6