Originally Posted by
REBCOMACHINE
:drowning:
'96 arrow 500 A2100 has recently been shutting the control down with a blue screen dump- says to contact your system admin. I have been recovering from this by reseating the boards and the control would come back and work properly, sometimes for a month. Now the control hangs in the diagnostic screen on realtime ws- it will pass, then move on to the main control startup screen and hang up on machine mode (3 of 12). The control then shows application startup timeout error - cnc.exe and mwlist.vbx value size is 0. Click ok on those errors and continues to load. Machine mode is not available- diagnostic screen is accessible and shows passed on everything, when I expand the bridge board ws it shows dma failed. Just cannot fire up machine and run it. I even tried the original clone drive and it does the same.
Has anyone encountered this, is it the bridge board, power supply, connections, motherboard, other? Any ideas would be appreciated.
power supply is 3 years old 450 w and seems to check good voltage.
cmos batteries are 3v
thanks
eric