This is the driver that came with my original Taig setup. I changed it out to a G540 a long time ago, but I am playing with some small steppers and I thought this card might be handy for testing. The problem is I don't have the XML file that accompanied it, and now that Paul is using G540s he doesn't have the XML for this card on his website any more. I was wondering if one of you gutys has the pinout configuration info, manual, or original XML for this card?
Results 1 to 2 of 2
-
05-27-2013, 02:47 AM #1
Registered
- Join Date
- Oct 2008
- Posts
- 2100
Older Deepgroove XML File / Driver
Bob La Londe
http://www.YumaBassMan.com
-
05-28-2013, 02:44 AM #2
Registered
- Join Date
- Oct 2008
- Posts
- 2100
I just got an email from Paul. He says the pins are the same as the G540. Just adjust for 8 micro steps instead of 10.
Bob La Londe
http://www.YumaBassMan.com
Reply With QuoteSimilar Threads
-
Deepgroove probe?
By ddgman2001 in forum FadalReplies: 2Last Post: 05-04-2013, 01:55 PM -
Deepgroove Probe
By kanton in forum Taig Mills / LathesReplies: 4Last Post: 02-17-2011, 04:27 PM -
Deepgroove mill lathe conversion
By kanton in forum Taig Mills / LathesReplies: 6Last Post: 09-11-2010, 06:49 PM -
Is deepgroove Xylotex?
By MechanoMan in forum XylotexReplies: 1Last Post: 01-05-2009, 06:44 PM -
Mach 3 driver config file
By Drakkn in forum Mach Software (ArtSoft software)Replies: 6Last Post: 08-10-2007, 08:17 PM
Posting Permissions
