[Big Chips]

I have yet to get this to work on my haas post...i have several ops parts that this would come in very handy instead of the usual flood selection


any ideas..

thanks in advance :banana::banana:

[bobcad guy]

not sure what your asking, but m7 usually turns on mist coolant in my experience.

[Big Chips]

v25 has a selection to flood or mist or turn off coolant... when selecting your tools and doing tool paths.

when i check it it does not work on the machine... i tried everything ...

just wondering if anyone else has it working...i dont even see it outputting M07 int he post gcode...

[bobcad guy]

then edit your post to output M7,my post is lines number 706, 707, and 708, to set m7 as mist. then, find out if your machine mister works with the M7 command by MDI'ing it, if so, your good, if not, you might need to set a parameter in your machine to accept M7 as the mist on

[jrmach]

My Haas does not have a Mister