Getting alarm code 39-89 during Machine Alignment Procedure
Getting alarm code 39-89 during Machine Alignment Procedure
bet it says more than that..... some of us are not cincinnati field service reps so do not have codes memorized from 30 yrs experience. but we may have worked on these machines for 30 years and can help you if u tell us what this criptic code also says on ur screen....
i am currently having the same issue. i will type up the details on the alarm code. Cause: Bit Z of S1AX_MOTION is ON, which indicates motion present in the C axis. Remedy : check the "in position" window value against the following error for the Z axis. Also, check the balance figure in closed loop mode is not excessive. This can be viewed and altered in the servo setup page
It would help to know what machine you are talking about, what control is on it and what drives you have!!!!
MIKE CNC Machine Services INC | Cincinnati Milacron MachinesCNC Machine Services
i have the same problem it is a cincinnati arrow 750, acramatic control 2100, with cincinnati BDS4 servos