Hi to all

thank's in advance, here is the problem:

just bought a laser engraving cutting machine with mpc6515 motion controller as motherboard (stand alone machine), the suppliers send the machine with 2 Cd's and a green softdog as the machine was sent assembled and operating, thus trying to install the software lasercut5.1 ends up with an error at the beginning with message: ""failed to get setup files"" and with lasercut5.3 the install go true but not with a complete communication with the machine, after trying to upgrade the firmware i receive now wrong files re-load configuration ,and when all set OK with lasercut5.3 i receive dll version don't much firmware version. please anyone who can help i am at a dead end with this machine and i had put all my saving for it so i can work freelance pleaaaaaase.

Sincerely you rs
Hicham.