Hi guys.
I recently purchased a nakamura tmc2 from a machine shop. It was hardly getting any use and they had new machines to install so needed the room.
It has a fanuc 6t control
Comes with a cupboard full of tool holders & soft jaws. Along with collets 3 jaw chuck turning tolls, drill chucks, drill sleeves and the list goes on.
All manuals were included.
Now for the catch.
The machine when making parts was being operated by a mate if mine. On the day I went to look at it he homed the machine and ran the spindle for a few minutes and set up a small demo program to show me later that day. When I got there I looked over the machine and opened the elect cabs to have a look. Then tried to power it up but just got a 'not ready' screen.
After many months went by and waiting for the owner to fix it I decided to make an offer as is. And it was brought for little money
http://www.cnczone.com/forums/fanuc/...t_looking.html