[heilcnc]

have 3 minebea miniangle step motors 23lm-c705 steppers i want to use but i lost the wiring diagram for them and cant find this motor on the internet it also says astrosyn they are 3volt 2.4amp 1.8 deg (they are not on the minebea website)please help thanks
realy need the wiring diagram for these so i can hook them up

[jeffs555]

I don't have a diagram, but it is not very hard to figure it out. If you have an ohm meter, it is a little easier, but you can do it with just a flashlight battery. This page describes some ways to do it. http://www.piclist.com/techref/io/stepper/wires.htm For 8 wire motors, I use the the technique described by Bill Krause about half way down the page.