As a follow on from my previous thread Is it possible to have Mach3 run some VB code at start up, if so how can this be done. My plan is to use VB code to put the Jog Mode into Cont at start up using OEM245.
Barry
As a follow on from my previous thread Is it possible to have Mach3 run some VB code at start up, if so how can this be done. My plan is to use VB code to put the Jog Mode into Cont at start up using OEM245.
Barry
Create the VB macro and save it as an M code, like M700.m1s, in your Mach3\macros\yourprofilename folder.
In General Config, put M700 in the Initialization string. This will run it when you start mach3 and press Reset.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Seems my reply never made it!
Thanks AGAIN Gerry for a quick response. All is working the way I want it to now.
Barry