I have a Mori Seiki MV 45/40 Mill w/MX2 control. I am needing to program a feedrate less than 1.0. However, the machine will not respond leaving me to dial it back at the control. Does anyone know if there is a parameter to allow programming a lower than 1.0 feedrate, for example (F.75).
Thanks
Greg
Thread: MV 45/40 YASNAC MX2 FEEDRATE
Results 1 to 1 of 1
-
07-12-2013, 05:08 PM #1
Registered
- Join Date
- Jul 2013
- Posts
- 4
MV 45/40 YASNAC MX2 FEEDRATE
Reply With QuoteSimilar Threads
-
Yasnac MX2 FEEDRATE
By METCAP in forum Community Club HouseReplies: 1Last Post: 07-15-2013, 05:25 PM -
Feedrate override vs programming a faster feedrate?
By Zeppelin1007 in forum Mach Software (ArtSoft software)Replies: 2Last Post: 01-11-2013, 10:38 PM -
Making the transition from Yasnac I80 control to Yasnac J300 control?
By 56Racing in forum PollsReplies: 4Last Post: 02-15-2012, 04:52 PM -
Z FeedRate Problems
By ednspace in forum MadCAMReplies: 2Last Post: 06-21-2010, 02:35 PM -
G02, G03 Feedrate !!!!!
By usb in forum CNC (Mill / Lathe) Control Software (NC)Replies: 2Last Post: 09-16-2008, 01:19 AM
Posting Permissions
