[Sheena on]

hi all if I send a program via pc or edit one of the programs in the memory it misses out the g13 or g14 line in auto but shows it in edit mode if I add g13 to the next line showing it takes the whole line off in auto can anyone help please
regards perry

[underthetire]

You sure your looking at the right page in auto? It should show upper turret on left side of screen, and lower on right.

[Algirdas]

the text in auto mode is for single turret in a window only. You can see separate texts for both turrets if you can set two windows in auto mode.
Edit mode displays full part program.

[topdawg]

You never see the G13 or G14 on the program screen.

[Sheena on]

hi all thanks for all the replies , I ran the program on the okuma and it used the upper turret as I asked so it must read the g13 g14 even if I cannot see it in auto but if I run the old programs in auto I can see the g13 or g14 ,so it must be the way I edit the program if I add a new line should I have the curser on the start or on the end of the last line ?as it seems to push the program up so I cannot see the top lines in auto mode