585,712 active members*
4,131 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Takisawa MAC-V0 tool turret problem

Thread: Takisawa MAC-V0 tool turret problem

Results 1 to 5 of 5
  1. 07-24-2013, 12:14 AM #1
    rai
    rai is offline Registered
    Join Date
    Feb 2006
    Posts
    213

    Takisawa MAC-V0 tool turret problem

    I have a Takisawa Drill tap center equipped with Fanuc OMC and Tool turret with NSK drive.
    In the morning whenever I am trying to on this machine it's tool turret rotate and vibrate without any command given to tool turret, even it's rotate no safe zone area and It's broke tool pockets couple of times.
    I have checked limit switches & sensors but no success.
    As donot have it's electrical circuit diagram, It is quite difficult to diag. this problem.
    Kindly somebody help me out from this problem.
    Reply With Quote Reply With Quote
  2. 07-26-2013, 06:37 AM #2
    rai
    rai is offline Registered
    Join Date
    Feb 2006
    Posts
    213
    Please somebody help me to get it's electrical diagram.
    [email protected]
    Reply With Quote Reply With Quote
  3. 08-20-2013, 05:05 PM #3
    greenery_fr
    greenery_fr is offline Member
    Join Date
    Sep 2008
    Posts
    138
    Yes I have electric Diagram
    Reply With Quote Reply With Quote
  4. 08-28-2013, 04:46 PM #4
    rai
    rai is offline Registered
    Join Date
    Feb 2006
    Posts
    213
    Thank you very much your reply, Is it possible to get electric circuit diagram fro Takisawa Mac-V0?
    I would much appriciate for sending me electric circuit diagram and what ever charges are there I am ready to bear.
    [email protected]
    Reply With Quote Reply With Quote
  5. 08-29-2013, 04:41 AM #5
    greenery_fr
    greenery_fr is offline Member
    Join Date
    Sep 2008
    Posts
    138
    Check your email
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Takisawa Mach-v3 tool carosel problem
    By Clayboy in forum Vertical Mill, Lathe Project Log
    Replies: 1
    Last Post: 01-17-2013, 04:06 PM
  2. TAKISAWA TC-1 Turret keep Hunting
    By parametric.ms in forum Fanuc
    Replies: 0
    Last Post: 02-10-2011, 08:58 AM
  3. turret problem for takisawa tc 2
    By anantwaykole in forum Community Club House
    Replies: 0
    Last Post: 12-29-2008, 03:03 PM
  4. Lathe tool turret problem
    By chrisryn in forum Uncategorised MetalWorking Machines
    Replies: 4
    Last Post: 06-17-2008, 08:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules