[2jzs4rx7]

hi, have had v25 for over 12 months and haven't used it much as I didn't know where to start until I bought the training package and it has had glitches and crashes until certain updates, and I've noticed after upgrade 996 ?
it now shows the ucs with z where the x should be?
and y pointing up where z should be
I've watched the videos and can't find how to edit a standard ucs..
I have a screen capture pic but not sure how to attach it using the forum on my phone, thanks Daniel

[Jessebobcad]

It sounds like you're in turning mode. At the top of the screen Click Modules> Turning Mode. This should correct your issue.

To set this so that it no longer opens with Lathe Coordinates go to the top of the screen Click Preferences> Settings Default in the new window on the left Click Units. On the new page you will see Lathe Coordinates (Z,X,Y) this should not be highlighted if it is Click it.

[2jzs4rx7]

indeed it did thanks for your help!