The spindle takes as much as 10 seconds to come up to speed.
Does anyone know the Gcode needed to make the machine wait for 10 or more seconds to givw the spindle time to reach the target RPM?
JA
Results 1 to 20 of 24
Threaded View
-
08-07-2013, 07:06 PM #1
Registered
- Join Date
- Jun 2012
- Posts
- 5
How do I add a 10 seconds delay after starting the spindle
Reply With QuoteSimilar Threads
-
spindle shuts off... runs for about 3 seconds then nothing
By williamsmotower in forum Charter Oak Automation Support ForumReplies: 2Last Post: 11-20-2013, 01:55 PM -
Spindle startup delay / dwell..
By kiwichris in forum LinuxCNC (formerly EMC2)Replies: 18Last Post: 09-05-2013, 06:07 AM -
Spindle delay
By mkc2 in forum Mach MillReplies: 3Last Post: 01-06-2009, 01:56 PM -
mach 3/boss 5 spindle shuts off by itself, will only run a few seconds
By tom.jelly in forum Bridgeport / Hardinge MillsReplies: 5Last Post: 11-25-2008, 07:18 PM -
mach 3 spindle delay
By mike10 in forum Mach MillReplies: 0Last Post: 05-10-2008, 05:50 AM
Posting Permissions
