I am trying to use the G31 skip move function on an Okuma MA600HB with an OSP 200 control. In my program I use probing cycle calls which use this function with no issue. I on the other hand have a problem somewhere becuase I turn off the feed limit and do a move which it does start moving, but when it touches the part it does not stop! Any certain reason why a probe doesn't stop when touching? It is a new machine and a new probe and like I said after digging through the Renishaw macros it is using the G31 quite a bit. Thanks!
M130
G31 X=LV11 Y=LV12 F200.
M131