they can't be what I would commonly think of a fixture as Sprut insists on running my 1/2" end mill right through them...
so if they are not for setting up a fixture (ie milling keep out area) what are they for? are they purely for decoration?
Results 1 to 2 of 2
-
09-01-2013, 10:11 PM #1
Registered
- Join Date
- Jul 2011
- Posts
- 297
I am curious, what is the point of "fixtures" under the Model tab?
-
09-01-2013, 11:11 PM #2
Registered
- Join Date
- Feb 2008
- Posts
- 389
If you have it set up right SC will avoid your fixtures.
I think there is video tutorial at SC America. I'm on the phone and I can't get you a link but if you search you will find it.
GerryCurrently using SC7 Build 1.6 Rev. 64105
Reply With QuoteSimilar Threads
-
FANUC 6M MODEL B CHANGE "[ ]" CHARACTER TO "( )"
By avaitsis in forum FanucReplies: 4Last Post: 05-28-2013, 09:20 PM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM -
"Floating" Y axis with fixtures...ARGH!!
By FFWD in forum Uncategorised MetalWorking MachinesReplies: 9Last Post: 11-16-2012, 10:30 PM -
"Floating" Y axis with fixtures...ARGHH!!
By FFWD in forum MetalWork DiscussionReplies: 2Last Post: 11-16-2012, 02:10 PM -
cant cut a circle? "current point same as end point of arc"
By maccrazy2 in forum DeskCNC Controller BoardReplies: 1Last Post: 02-14-2012, 07:15 AM
Posting Permissions
