Quick question about our Hardinge CHNC II Flatbed Lathe. Do you know how to purge the lube pump? Installed a new pump and need to pump oil thur the system. Keep getting an lube alarm(Lube pump failure). Do you hold down the start button?
Quick question about our Hardinge CHNC II Flatbed Lathe. Do you know how to purge the lube pump? Installed a new pump and need to pump oil thur the system. Keep getting an lube alarm(Lube pump failure). Do you hold down the start button?
Dear Sir
What is the CNC control ? you have to check the Level Switch of Lube Pump it is in NC or not ? Next , If you can tell the exact CNC control Model , Than Troubleshooting will be better as i recall from my service Experience it is Fanuc 15 Control with Color CRT .
Please confirm
Regards
Got it repaired, but thanks for the reply. Control was Fanuc GN- 10F. Yes old. The only way is to turn on & off serveral times. Learned this from a call to Morris South. My problem ended up being low air pressure. Installed a new air regulator that was behind the front panel just for the lub pump.