I am trying to set up a touch plate to a 4xis tb6560 board. Mach3 throws a estop at limits. How do I setup to back off at limits.
I am trying to set up a touch plate to a 4xis tb6560 board. Mach3 throws a estop at limits. How do I setup to back off at limits.
I don't really understand the problem or question, but it sounds like noise is triggering your limit switch inputs.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)