585,930 active members*
3,303 visitors online*
Register for free
Login

Thread: 1250 lancer start up

Results 1 to 4 of 4
  1. 10-10-2013, 03:04 AM #1
    CMmetals
    CMmetals is offline Registered
    Join Date
    Oct 2013
    Posts
    14

    Post 1250 lancer start up

    when the machine comes up and puch the power button the second time the drives some on and right back off i have checked the limit switches, over travel, and the sencers it will run as long as i hold the button it wat could it be
    Reply With Quote Reply With Quote
  2. 10-10-2013, 03:23 PM #2
    maver1ck
    maver1ck is offline Registered
    Join Date
    Mar 2011
    Posts
    462
    Do you have prints for the machine? Page 5 usually shows the bypass circuit that is causing your problem. I don't think I've ever run into anything but the limit switches causing it, but that page should show you all the possibilities.
    Reply With Quote Reply With Quote
  3. 10-10-2013, 05:25 PM #3
    CMmetals
    CMmetals is offline Registered
    Join Date
    Oct 2013
    Posts
    14
    yea i bypassed them and it still didn't change anything
    Reply With Quote Reply With Quote
  4. 10-12-2013, 08:40 PM #4
    maver1ck
    maver1ck is offline Registered
    Join Date
    Mar 2011
    Posts
    462
    What voltage do you have going into and out of each switch you jumpered? You could have a broken wire or a bad connection somewhere in the chain creating the same situation as if the switch was open.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Cincinnati lancer 1250 power up
    By CMmetals in forum Cincinnati CNC
    Replies: 4
    Last Post: 10-09-2013, 03:35 AM
  2. Lancer 1250 Drawbar Solenoid Valve Sticking
    By LAIR82 in forum Cincinnati CNC
    Replies: 4
    Last Post: 08-08-2013, 08:29 PM
  3. Need CAD 3D and CNC Free Lancer!
    By betch23 in forum Want To Buy...Need help!
    Replies: 1
    Last Post: 01-17-2011, 07:26 PM
  4. New from AQE... GRINDMASTER 1250 Portable Downdraft Table 1250 CFM!
    By DaveG@AQE in forum News Announcements
    Replies: 0
    Last Post: 03-30-2009, 03:55 PM
  5. Cincinnati Arrow 500 and Lancer 1250 Program Storage
    By Chaz in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 3
    Last Post: 10-10-2007, 03:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules