Hi Anthony, my name is Atanas from Montreal. I just get registered on this site and I sow that you have a good experiance with the Toyoda. I hope that you could help me .
Here is my problem: I have a Toyoda BM 1200 with Fanuc 18i-MB.
For some reason my tool magazin (30 tool ) stop counting my tools located in pot 10 to 15. Other wise as soon as my counter hits hexadecimal "A" to "F" tools based in these pots are invisible on the screen.
If I keep going with my "Magazin CW" button, at dec."16" - hex. "10" my screen start showing tool located at pots 16,17,18 e.t.c till 25 (1A hex.). And then after the same happen again and again. It looks like any time my counter reach the letters for some reason the numbers are not showed on the screen.
I reset the magazine - at "PMC", "Data"(there is no G.Data on that one) my D0000 is 99. At D0001 I put 1, D0002 I put 2......till D0030=30. That didn't change anything!!!.
My counter for the magazine is C0000 or C0002 (I thing ??). The value is 48 (I don't now why, but any other values that I put, the magazine stop counting at all!!!) In the ladder I can see the counter going from 0 to 2F (dec.48) no problem.
My sensors : "magazine cw", "magazine in position" and "tool pot No.1" are working fine ( I can see them in the "diagnostics".
I load PMC prm. and NC prm. from. manifacture CD rom. Still the same problem!!!
Do you thing you could help me.
Thanks